A real tree needs a corner and a real fireplace needs a chimney. Plenty of homes have neither to spare, and a rented one usually comes with a lease clause about nails. Christmas paper DIY decorations get around all three: a pack of peel and stick sheets, a knife and an afternoon can put a tree, a hearth or a wrapped-present door on a plain painted wall, and every bit of it lifts off again in January.
The ideas below stay on the walls, around the fireplace and in the bedroom. If you are dressing the table and sideboard, our guide to Christmas dining room decorations picks up where this one stops.
Where Christmas paper DIY decorations work, and where they don't
Paper is only as good as the wall under it. Main Street lists three best surfaces on its how-to-use page: smooth tile, sealed wood and painted drywall that is clean, flat and dry. The same page names four to avoid: ceilings, textured or popcorn drywall, brick or stone walls, and areas exposed to moisture such as bathrooms and showers. A brick chimney breast falls on the wrong side of that list, which matters later.
Two more checks before you cut:
- Fresh paint. If you painted recently, Main Street asks you to wait at least four weeks before applying.
- A test patch. Press a small offcut somewhere out of sight, leave it a day, then peel it. If it comes away cleanly, carry on.
The tool list is short: a measuring tape and pencil, a utility knife, a damp cloth and a smoothing tool. Add a level, because a leaning tree is the one detail every guest spots.
Every wall sheet mentioned here is 11 x 16 inches, about 1.22 square feet, sold in 12-packs that cover roughly 14.6 square feet.
DIY Christmas wall decor: a stepped paper tree
A wall tree suits a studio, a dorm or a hallway too narrow for anything with branches, and built from whole sheets it needs little cutting.
The layout
Turn the sheets landscape, so each one is 16 inches wide and 11 inches tall, and stack them in rows that shrink by one sheet as they climb:
- Four rows (4, 3, 2, 1): 10 sheets, a base 64 inches wide and a tree 44 inches tall.
- Three rows (3, 2, 1): 6 sheets, 48 inches wide and 33 inches tall. A good size above a dresser or a bed.
Center each row over the one below, which shifts it 8 inches in from each side. For a true triangle instead of steps, pencil a line from the top center of the highest sheet down to each end of the base row and trim along it with the knife once everything is on the wall.
These counts are our own arithmetic, not a product spec, so measure first. For the print, Branches and Berries is the obvious pick: watercolor branches with tiny white berries on soft green. Either tree leaves sheets spare in a 12-pack for a trunk, or cut one from a wood-grain sheet such as Distressed Wood Grey.
Decorating it
Cut circles from Candy Stripe for baubles and press them onto the tree. Sheet on sheet is not on the official surface list, so stick one bauble first and check it the next day before you add the rest. A gold star cut from Glow Getter, the embossed foil craft panel at 10 x 15 inches, finishes the top. For ornaments the family can add to, cut shapes from Chalkboard Classic, a matte black writable panel measuring 11 x 15 inches that takes chalk and chalk markers, and let everyone write a name or a wish on one.
A faux fireplace for a home without one
The trick is a brick surround, a dark opening, and real furniture in front to carry the stockings.
The brick surround
Red Bricks is a realistic brick pattern in reds, terracotta and earthy tones. It is printed paper, so it goes on painted drywall like any other sheet. Working in portrait (11 inches wide, 16 tall):
- Draw a level line 32 inches above the baseboard. Lay two rows of four sheets below it, a field 44 inches wide, but leave out the two middle sheets of the bottom row. That gap, 22 inches wide and 16 tall, is your firebox.
- Add two more sheets centered above the top row for a chimney breast 22 inches wide.
- That uses eight sheets and leaves four in the pack for trimming and repairs.
The firebox
Two Chalkboard Classic panels placed side by side in portrait cover 22 by 15 inches, an inch short of the opening. Align them with its top edge and fill the bottom inch with a band cut from a spare brick sheet, which reads as a hearth lip. Draw the logs and flames in chalk marker.
The mantel
Never hang anything from the sheets themselves. Push a slim console table or a low bench against the bottom of the surround and let its top be the mantel. Weighted stocking holders sit on it, and so do a garland and a few candles. Make those battery candles, since the brand publishes no heat rating for its sheets.
Decorating around a real fireplace
A working fireplace changes the rules. Fire departments, repeating federal holiday safety guidance, tell households to keep a Christmas tree at least three feet from heat sources such as fireplaces. Paper deserves the same caution, and Main Street publishes no heat rating for its sheets. So skip the surround, the mantel shelf and the chimney breast entirely. Most surrounds are brick or stone anyway, which the how-to-use page already lists as a surface to avoid.
That still leaves good places for DIY fireplace Christmas decor:
- The alcoves. Painted recesses beside the chimney breast take a tall panel of sheets and frame the fireplace without touching it.
- The wall facing it. Put the stepped tree opposite, so the two face each other.
A purely decorative fireplace that is never lit is a different case. If the wall above it is painted drywall, treat it like any other wall.
Wrap a bedroom door like a present
This one costs about four sheets and gets the biggest reaction of anything here. Most interior doors are painted, which matches the painted, sealed and finished surfaces the product pages ask for. Keep it to doors inside the house, away from weather.
- Measure your door. Most interior doors are 80 inches tall, but check before you cut.
- Slice Candy Stripe sheets in half lengthwise to make ribbons 5.5 inches wide and 16 inches long.
- Run a vertical band down the center of the door: five ribbons end to end covers 80 inches. Match the diagonal stripes at each join so the seams disappear.
- Cross it with a horizontal band at about two-thirds height. A 32-inch door takes two ribbons.
- Cut a bow from the leftovers and press it over the crossing point.
Stop the bands just short of the door edges and the latch, so nothing rubs against the frame each time the door closes. Covering the whole face of a 32 x 80 inch door instead takes about 15 sheets, so plan on two packs.
Christmas bedroom decor that comes down in January
A holiday headboard
A painted wall behind the bed can take a seasonal headboard. Eight sheets of Branches and Berries laid landscape, four across and two down, make a panel 64 inches wide and 22 inches tall, enough to clear the width of a queen mattress. Round the top corners using a dinner plate as a template. For a permanent version, our bedroom accent wall ideas have more.
A child's wall
Children like decorations they can reach. Trees and Lights shows little trees topped with gold stars, colored string lights and festive phrases on a blush background, and a low band of it at their eye level becomes their own corner. Put one Chalkboard Classic panel in the middle of the band for a letter to the North Pole that can be rewritten every night.
Leftover strips make bunting for a shelf or flat paper ornaments; our list of Christmas crafts for adults has plenty of ways to use the scraps.
In January, peel each sheet back slowly at a low angle, close to the wall. Our guide on how to remove peel and stick wallpaper walks through the details.
Frequently asked questions
Can you put peel and stick wallpaper on a fireplace?
Not on a working one. Fire-safety guidance asks for at least three feet between a Christmas tree and a fireplace, the same caution suits paper, and Main Street publishes no heat rating for its sheets. Most surrounds are brick or stone, which the brand lists as surfaces to avoid. Decorate the painted alcoves or a nearby wall instead, or build a faux fireplace on a wall elsewhere.
How many sheets do I need for a paper Christmas tree on the wall?
Using 11 x 16 inch sheets turned landscape, a three-row stepped tree takes 6 sheets and stands about 33 inches tall and 48 inches wide. A four-row tree takes 10 sheets and reaches about 44 by 64 inches. Either fits in one 12-pack, with sheets left over for a trunk or ornaments.
Will paper Christmas decorations damage my walls?
The sheets are sold as removable and repositionable, and the product pages describe them as perfect for renters. Results still depend on the wall. Use them on clean, smooth painted drywall, wait at least four weeks after painting, and run a small test patch first. When you take them down, peel slowly at a low angle.
Can I stick paper decorations on a brick wall?
Main Street lists brick and stone walls among the surfaces to avoid, because the adhesive needs a flat surface to grip. If you want a brick look, do it the other way around: put Red Bricks sheets on a smooth painted wall. They are printed paper, so they give you the brick without the uneven surface.
What is the easiest DIY Christmas room decor for renters?
A wrapped bedroom door. It takes about four sheets of Candy Stripe and a utility knife, and most interior doors are painted, which matches the painted, sealed and finished surfaces the product pages ask for. Keep the bands clear of the door edges and latch, and it comes off in January with the rest of the decorations.
Featured in this article
Shop the wallpapers mentioned above.
Crafts to Do With Scrapbook Paper: Seven Projects That Use It Up
Christmas Paper DIY Decorations for Walls, Fireplaces and Bedrooms
Dollar Tree DIY Christmas Decorations: 8 Paper Makeovers for Decor and Gifts
Christmas Crafts for Adults: Paper Projects for One Evening
How to Clean Shelf Liner and Contact Paper, Type by Type








